Deleting The Port Security Database; Clearing The Port Security Database - Cisco AJ732A - MDS 9134 Fabric Switch Configuration Manual

Database Interaction
S e n d f e e d b a c k t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
Use the port-security database copy vsan command to copy from the active to the configured database.
If the active database is empty, this command is not accepted.
switch# port-security database copy vsan 1
Use the port-security database diff active vsan command to view the differences between the active
database and the configuration database. This command can be used when resolving conflicts.
switch# port-security database diff active vsan 1
Use the port-security database diff config vsan command to obtain information on the differences
between the configuration database and the active database.
switch# port-security database diff config vsan 1

Deleting the Port Security Database

Tip If the distribution is enabled, the deletion creates a copy of the database. An explicit port-security
commit command is required to actually delete the database.
Use the no port-security database vsan command in configuration mode to delete the configured
database for a specified VSAN.
switch(config)# no port-security database vsan 1

Clearing the Port Security Database

Use the clear port-security statistics vsan command to clear all existing statistics from the port security
database for a specified VSAN.
switch# clear port-security statistics vsan 1
Use the clear port-security database auto-learn interface command to clear any learned entries in the
active database for a specified interface within a VSAN.
switch# clear port-security database auto-learn interface fc2/1 vsan 1
Use the clear port-security database auto-learn vsan command to clear any learned entries in the
active database for the entire VSAN.
switch# clear port-security database auto-learn vsan 1
Note The clear port-security database auto-learn and clear port-security statistics commands are only
relevant to the local switch and do not acquire locks. Also, learned entries are only local to the switch
and do not participate in distribution.
Use the port-security clear vsan command to clear the pending session in the VSAN from any switch
in the VSAN.
switch# clear port-security session vsan 5
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
45-18
Chapter 45 Configuring Port Security
OL-16597-01