Traffic Storm Control Example Configuration; Default Settings - Cisco AJ732A - MDS 9134 Fabric Switch Configuration Manual

Traffic Storm Control Example Configuration

S e n d f e e d b a c k t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
Traffic storm control uses a 10-microsecond interval that can affect the operation of traffic storm control.
Note
To display traffic storm control counters on an interface, perform this task:
Command
Step 1
switch# show interface [ethernet
slot/port | port-channel number]
counters storm-control
Traffic Storm Control Example Configuration
The following example shows how to configure traffic storm control:
switch# configure terminal
switch(config)# interface ethernet 1/4
switch(config-if)# storm-control broadcast level 40
switch(config-if)# storm-control multicast level 40
switch(config-if)# storm-control unicast level 40

Default Settings

Table 15-1
Table 15-1
Parameters
Traffic storm control
Threshold percentage
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
15-4
lists the default settings for traffic storm control parameters.
Default Traffic Storm Control Parameters
Chapter 15
Purpose
Displays the traffic storm control counters.
Default
Disabled
100
Configuring Traffic Storm Control
OL-16597-01