Importing And Exporting Zone Sets - Cisco AJ732A - MDS 9134 Fabric Switch Configuration Manual

Chapter 38 Configuring and Managing Zones
S e n d f e e d b a c k t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
•
•
•
Figure 38-5
active zone set mismatch

Importing and Exporting Zone Sets

To import or export the zone set information from or to an adjacent switch, perform this task:
Command
Step 1
switch# zoneset import interface fc
slot/port vsan vsan-id
switch# zoneset import interface fc
slot/port vsan vsan-id
Step 2
switch# zoneset export vsan vsan-id
switch# zoneset export vsan vsan-id
Note Perform the import and export operations from a single switch. Importing from one switch and exporting
from another switch can lead to isolation again.
OL-16597-01
Import the neighboring switch's active zone set database and replace the current active zone set (see
Figure 38-5).
Export the current database to the neighboring switch.
Manually resolve the conflict by editing the full zone set, activating the corrected zone set, and then
bringing up the link.
Importing and Exporting the Database
Isolated port due to
Switch 1
From Switch 1, Import
database forces Switch 1
to use the database
configured in Switch 2
From Switch 1, Export
database forces Switch 2
to use the database
configured in Switch 1
Purpose
Imports the zone set from the adjacent switch
connected through the specified interface for the
VSAN .
Imports the zone set from the adjacent switch
connected through the specified interface for the
VSAN range.
Exports the zone set to the adjacent switch connected
through the specified VSAN.
Exports the zone set to the adjacent switch connected
through the specified range of VSANs.
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
Zone Set Distribution
Switch 2
38-15