Configuring Zones - Cisco AJ732A - MDS 9134 Fabric Switch Configuration Manual

Chapter 38 Configuring and Managing Zones
S e n d f e e d b a c k t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m

Configuring Zones

To configure a zone and assign a zone name, perform this task:
Command
Step 1
switch# configuration terminal
Step 2
switch(config)# zone name zone-name vsan
vsan-id
Step 3
switch(config-zone)# member type value
Tip
Table 38-1
Domain ID
FC alias
FC ID
Fabric pWWN
Local sWWN interface
Domain ID interface
Remote sWWN interface
pWWN
Use the show wwn switch command to retrieve the sWWN. If you do not provide a sWWN, the software
Tip
automatically uses the local sWWN.
The following examples show how to configure zone members:
switch(config)# zone name MyZone vsan 2
pWWN example:
switch(config-zone)# member pwwn 10:00:00:23:45:67:89:ab
OL-16597-01
Use a relevant display command (for example, show interface or show flogi database) to
obtain the required value in hex format.
Type and Value Syntax for the member Command
Purpose
Enters configuration mode.
Configures a zone in the specified VSAN.
All alphanumeric characters or one of the
Note
following symbols ($, -, ^, _) are supported.
Configures a member for the specified zone based on
the type (pWWN, fabric pWWN, FC ID, fcalias,
domain ID, or interface) and value specified. See
Table 38-1 for details.
Caution You must only configure pWWN-type
zoning on all SAN switches running Cisco
NX-OS if there is a Cisco MDS 9020
switch running FabricWare in the same
fabric.
member domain-id domain-id portnumber number
member fcalias fc-alias-name
member fcid fcid
member fwwn fwwn-id
member interface type slot/port
member interface type slot/port domain-id domain-id
member interface type slot/port swwn swwn-id
member pwwn pwwn-id
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
Configuring Zones
38-7