Verifying Traffic Storm Control Configuration
Verifying Traffic Storm Control Configuration
To display traffic storm control configuration information, perform one of these tasks:
Command
switch# show interface [ethernet slot/port |
port-channel number] counters storm-control
switch# show running-config interface
Traffic Storm Control Example Configuration
The following example shows how to configure traffic storm control:
switch# configure terminal
switch(config)# interface ethernet 1/4
switch(config-if)# storm-control broadcast level 40
switch(config-if)# storm-control multicast level 40
switch(config-if)# storm-control unicast level 40
Default Traffic Storm Settings
The following table lists the default settings for traffic storm control parameters.
Table 22: Default Traffic Storm Control Parameters
Parameters
Traffic storm control
Threshold percentage
Cisco Nexus 5000 Series NX-OS Layer 2 Switching Configuration Guide, Release 5.0(3)N1(1)
236
Configuring Traffic Storm Control
Purpose
Displays the traffic storm control configuration for
the interfaces.
Traffic storm control uses a 10-microsecond
Note
interval that can affect the operation of traffic
storm control.
Displays the traffic storm control configuration.
Default
Disabled
100