Exiting Screen Saver Mode; Activating Screen Saver Mode Without Password Protection; Deactivating The Screen Saver; Configuring The Switch And Share Modes - HP AF600A - Server Console Switch User Manual

Exiting screen saver mode

To exit the Screen Saver mode, press any key or move the mouse. The Main dialog box
Main dialog box" on page 17) is displayed.

Activating Screen Saver mode without password protection

If your HP KVM Server Console Switch G2 does not require a password to gain access to the
1.
Security dialog box
-or-
If your HP KVM Server Console Switch G2 is password protected, refer to the Deactivating the
Screen Saver (on page 31) section, then go to step 2.
Select Enable Screen Saver.
2.
Enter the number of minutes for Inactivity Time (1 to 99) to delay activation of the screen saver.
3.
(Optional) Click Test to activate the screen saver test, which lasts 10 seconds, then returns you to the
4.
Security dialog box.
Click OK to save settings.
5.
CAUTION:
compliant with Energy Star®.
NOTE:
from a server. The status flag displays Free.

Deactivating the screen saver

From the Security dialog box
1.
Screen Saver.
Click OK to save settings.
2.
To immediately activate the screen saver, press the Print Scrn key, and then press the Pause key. This
command only works when the user is connected to a server.

Configuring the Switch and Share modes

The Switch window can be used to set one of the following switch modes:
•
Preemptive (default setting)—Enables any user to select any server at any time; a request from
another user disconnects the current user without warning.
•
Cooperative—Maintains the current user connection; the current user will not be disconnected if
another user requests connection.
You can also enable or disable Share mode and specify a time-out period from the Switch window. Share
mode enables two users to access a primary server.
("Accessing the Security dialog
Monitor damage can result from the use of energy mode with monitors not
No server is selected after the activation of the screen saver mode disconnects the user
("Accessing the Security dialog
box" on page 29), proceed to step 2.
box" on page 29), deselect Enable
("Accessing the
Local port operation 31