Activating Scan Mode; Deactivating Scan Mode; Setting Local Console Switch Security - HP AF600A - Server Console Switch User Manual

Click Clear to remove all servers from the scan list.
Click OK to save settings.
2.

Activating Scan mode

From the Commands dialog box
1.
Enable.
Click X to close the Commands dialog box.
2.
NOTE:

Deactivating Scan mode

If the OSD is open, select a server.
-or-
If the OSD is not open, move the mouse or press any key on the keyboard. Scanning stops at the currently
selected server.
-or-
From the Commands dialog box
Enable. Any active connections on the local port are disconnected.

Setting local console switch security

The OSD enables you to set security on the local port consoles. You can establish a Screen Saver mode
that engages after the HP KVM Server Console Switch G2 remains unused for a user-definable time
delay. When engaged, the HP KVM Server Console Switch G2 remains locked until any key is pressed or
the mouse is moved. Then you can enter the password to log in.
Use the Security dialog box
Server Console Switch G2 with password protection, set or change the password, and enable the screen
saver.
NOTE:
access the Security dialog box.
("Accessing the Commands dialog
The scanning begins as soon as you click Scan.
("Accessing the Commands dialog
("Accessing the Security dialog
If a password has been previously set, you must enter the password before you can
box" on page 38), select Scan
box" on page 38), deselect Scan
box" on page 29) to lock your HP KVM
Local port operation 28