Assembling The Inner Rails - HP AA979A - StorageWorks SAN Switch 2/8V Installation Manual

Note:
rails. Each switch requires a different number of these screws. For example,
shows the an inner rail being attached to the SAN Switch 2/16V with five screws.
Attaching both inner rails requires ten screws.
Figure 10: Assembling the inner rails
Note:
SEMS screws
SAN Switch 2/8V, 2/16V and 2/16N Installation Guide
a. Assemble the two inner rails (one on each side) to the switch using the
appropriate number (from
Phillips pan-head SEMS screws as shown in
The rail kit provides fourteen #8-32 x 5/16-inch screws for assembling the inner
For factory integration only, tighten the
and torque between 6 to 8 inch-pounds.
step 5 on page 42) of #8-32 x 5/16-inch
Figure
#8-32 x 5/16-inch Phillips pan-head
Installing the SAN Switch
10.
Figure 10
0012a
43