Installing the SAN Switch
5. If the serial port is no longer required, log out of the serial console, remove the
Note:
from foreign material.
Create an Ethernet Connection and Log In
Use these steps to create an Ethernet connection.
1. Connect an Ethernet cable to the Ethernet port and to the workstation or to an
Figure 16: Connecting the Ethernet cable
2. Log in to the switch by telnet, using the admin account.
52
serial cable, and replace the safety plug in the serial port.
Any time the port is not in use, the safety plug should be installed to protect it
Ethernet network containing the workstation
1 0
1 0
0 -2
0 -2
4 0
4 0
V A
C 1
C 1
.0 A
.0 A
4 7
4 7
-6 3
-6 3
H z
H z
I O
I O
I O
I O
!
I
I
After this connection is made, the switch can be accessed remotely, by
command line or by Advanced Web Tools. Ensure that the switch is not being
modified from any other connections during the remaining steps.
(Figure
1 0
1 0
0 -2
0 -2
4 0
4 0
V A
C 1
C 1
.0 A
.0 A
4 7
4 7
-6 3
-6 3
H z
H z
SAN Switch 2/8V, 2/16V and 2/16N Installation Guide
16).
0016a