Managing the SAN Switches
Powering the Switch On and Off
To apply power to the SAN Switch 2/8V or SAN Switch 2/16V, connect at least
one power cable to an AC receptacle on the switch and to a power source. The
switch runs POST (power-on self-test) by default each time it is powered on, reset,
or rebooted, and requires as long as 3 minutes.
To end the flow of power to the SAN Switch 2/8V or SAN Switch 2/16V, remove
the power cord from the power source.
Note:
returned to their initial state the next time the switch is powered on.
58
Removing all power from the switch triggers a system reset. All devices are
SAN Switch 2/8V, 2/16V and 2/16N Installation Guide