IBM 88631SU - System x3850 - 8863 Service Manual page 101

v Follow the suggested actions in the order in which they are listed in the Action column until the problem
is solved.
v See Chapter 3, "Parts listing, Type 8863, 7362," on page 107 to determine which components are customer
replaceable units (CRU) and which components are field replaceable units (FRU).
v If an action step is preceded by "(Trained service technician only)", that step must be performed only by a
trained service technician.
Error code Description
180-xxx-006 Failed memory card LED test.
180-xxx-007 Failed power supply fan LED test.
180-xxx-008 Failed I/O board LED test.
180-xxx-009 Failed Active
201-198-000 Memory Test Aborted: Could not run the
test; suspect microprocessor tray error.
201-198-00n Memory Test Aborted: Could not run the
test.
Note: n = 1-9 (programming error).
™
PCI LED test.
Action
1. Reseat the following components:
a. Memory card
b. Microprocessor tray
c. I/O board
2. Replace the following components one at a time,
in the order shown, restarting the server each
time.
a. Memory card
b. (Trained service technician only)
Microprocessor tray
c. I/O board
1. Reseat the following components:
a. Power supply
b. (Trained service technician only) Power
supply structure
c. I/O board
2. Replace the components listed in step 1 one at a
time, in the order shown, restarting the server
each time.
1. Reseat the I/O board.
2. Replace the I/O board.
1. Reseat the following components:
a. (Trained service technician only) PCI-X switch
card assembly
b. I/O board
2. Replace the components listed in step 1 one at a
time, in the order shown, restarting the server
each time.
1. Restart the server.
2. Run the diagnostic test again.
3. Reinstall the diagnostic programs (see "Updating
the firmware" on page 147).
4. (Trained service technician only) Replace the
microprocessor tray.
1. Restart the server.
2. Run the diagnostic test again.
3. Reinstall the diagnostic programs (see "Updating
the firmware" on page 147).
85
Chapter 2. Diagnostics