Table of Contents
Advertisement
3. Restart the server.
In the event that the above sequence fails, the server might not restart correctly or
might not display video. Complete the following steps to force a manual restore
operation:
10. When you are asked whether you want to save the current code to a diskette,
11. Type 1 and press Enter to continue.
12. When the update is completed, turn off the server.
13. Remove ac power from the server.
14. Move the J14 jumper back to pins 1 and 2 to return to startup from the primary
15. Wait 30 seconds, then reapply ac power to the server.
16. Replace the cover; then, restart the server.
System-error log messages
A system-error log is generated only if a Remote Supervisor Adapter II SlimLine is
installed. The system-error log can contain messages of three types:
Information
Warning
Error
Each message contains date and time information, and it indicates the source of
the message (POST/BIOS or the service processor).
Note: The BMC log, which you can view through the Configuration/Setup Utility
program, also contains a large number of information, error, and warning messages.
In the following example, the system-error log message indicates that the server
was turned on at the recorded time.
1. Read the safety information beginning on page vii and "Handling
static-sensitive devices" on page 114.
2. Turn off the server and peripheral devices and disconnect all external cables
and power cords; then, remove the cover.
3. Locate the boot block recovery jumper (J14 on the I/O board) (see "I/O board
internal connectors and jumpers" on page 8).
4. Remove ac power from the server.
5. Move the J14 jumper to pins 2 and 3 to enable the backup page.
6. Wait 30 seconds, then reapply ac power to the server.
7. Insert the BIOS flash diskette into the external diskette drive.
8. Restart the server.
9. When POST starts, select 1 - Update POST/BIOS from the menu that
contains various flash (update) options.
type N.
Attention:
Do not restart or power-off the server until the update is
completed.
page.
Information messages do not require action; they record significant
system-level events, such as when the server is started.
Warning messages do not require immediate action; they indicate
possible problems, such as when the recommended maximum
ambient temperature is exceeded.
Error messages might require action; they indicate system errors,
such as when a fan is not detected.
89
Chapter 2. Diagnostics
Advertisement
Table of Contents
