Mld Snooping - NETGEAR GS728TS Admin Manual

Gigabit smart switches
Hide thumbs Also See for GS728TS:
Table of Contents

Advertisement

GS728TS, GS728TPS, GS752TS, and GS752TPS Gigabit Smart Switches
The following table describes the information available on the Querier VLAN Status page.
Field
VLAN ID
Operational State
Operational Version
Last Querier Address
Last Querier Version
Operational Max Response
Time
Click Refresh to redisplay the page with the latest information from the switch.

MLD Snooping

MLD is a protocol used by IPv6 multicast routers to discover the presence of multicast
listeners (nodes wishing to receive IPv6 multicast packets) on its directly attached links and
to discover which multicast packets are of interest to neighboring nodes. MLD is derived from
IGMP; MLD version 1 (MLDv1) is equivalent to IGMPv2 and MLD version 2 (MLDv2) is
equivalent to IGMPv3. MLD is a subprotocol of Internet Control Message Protocol version 6
(ICMPv6), and MLD messages are a subset of ICMPv6 messages, identified in IPv6 packets
by a preceding Next Header value of 58.
The switch can snoop on both MLDv1 and MLDv2 protocol packets and bridge IPv6 multicast
data based on destination IPv6 Multicast MAC Addresses. The switch can be configured to
perform MLD Snooping and IGMP Snooping simultaneously.
MLD Snooping Configuration
In IPv4, Layer 2 switches can use IGMP Snooping to limit the flooding of multicast traffic by
dynamically configuring Layer 2 interfaces so that multicast traffic is forwarded to only those
interfaces associated with IP multicast address. In IPv6, MLD snooping performs a similar
function. With MLD snooping, IPv6 multicast data is selectively forwarded to a list of ports
Description
Specifies the VLAN ID on which the IGMP Snooping Querier is
administratively enabled and for which VLAN exists in the VLAN database.
Specifies the operational state of the IGMP Snooping Querier on a VLAN:
• Querier: The snooping switch is the querier in the VLAN. The snooping
switch will send out periodic queries with a time interval equal to the
configured querier query interval. If the snooping switch sees a better
querier (numerically lower) in the VLAN, it moves to non-querier mode.
• Non-Querier: The snooping switch is in non-querier mode in the VLAN. If
the querier expiry interval timer expires, the snooping switch moves into
querier mode.
• Disabled: The snooping querier is not operational on the VLAN. The
snooping querier moves to disabled mode when IGMP snooping is not
operational on the VLAN, when the querier address is not configured, or
the network management address is not configured.
Displays the IGMP protocol version of the operational querier.
Displays the IP address of the last querier from which a query was snooped
on the VLAN.
Displays the IGMP protocol version of the last querier from which a query
was snooped on the VLAN.
Displays the maximum response time to be used in the queries that are sent
by the snooping querier.
147

Advertisement

Table of Contents
loading

This manual is also suitable for:

Gs752tpsGs752tsGs728tps

Table of Contents