NETGEAR GS728TS Admin Manual page 236

GS728TS, GS728TPS, GS752TS, and GS752TPS Gigabit Smart Switches
• ACL Based on Source IPv4 - Use this to create a ACL based on the source IPv4
address and IPv4 address mask.
• ACL Based on Destination IPv6 - Use this to create a ACL based on the destination
IPv6 prefix and IPv6 prefix length.
• ACL Based on Source IPv6 - Use this to create a ACL based on the source IPv6
prefix and IPv6 prefix length.
• ACL Based on Destination IPv4 L4 Port - Use this to create a ACL based on the
destination IPv4 layer4 port number.
• ACL Based on Source IPv4 L4 Port - Use this to create a ACL based on the source
IPv4 layer4 port number.
• ACL Based on Destination IPv6 L4 Port - Use this to create a ACL based on the
destination IPv6 layer4 port number.
• ACL Based on Source IPv6 L4 Port - Use this to create a ACL based on the source
IPv6 layer4 port number.
2. In the Rule ID field, enter a whole number in the range of (1 to 10) that will be used to
identify the rule.
3. In the Action field, specify what action should be taken if a packet matches the rule's
criteria. The choices are permit or deny.
4. In the Match Every field, specify True or False. If you select True, all packets are considered
to match the rule criteria, and no other fields are configurable.
5. Specify the match criteria for the rule. The fields available for match criteria input depend on
the selected ACL type.
6. To add a new rule to the ACL, select the check box next to the Rule ID, then click Add. You
can add multiple rules to the same ACL type.
7. In the Binding Configuration area, specify the packet filtering direction for an ACL in the
Direction field. The only valid direction is Inbound.
8. In the Port Selection Table area, select the interfaces for ACL mapping. All non-routing
physical ports and LAGs are listed.
9. To cancel the configuration on the screen. Reset the data on the screen to the latest value of
the switch, then click Cancel.
10. To send the updated configuration to the switch, click Apply. Configuration changes take
effect immediately.
236