NETGEAR GS728TS Admin Manual page 67

GS728TS, GS728TPS, GS752TS, and GS752TPS Gigabit Smart Switches
To configure the mode of the stack ports:
1. Select the check box associated with the unit and port to configure:
2. From the Configured Stack Mode field, select the operating mode:
• Stack. The port connects to the stack port on another stack member. This is the
default value.
• Ethernet. The port operates as a standard switch port that receives and transmits
network traffic
3. Click Apply to apply the new settings to the system.
4. Click Cancel to cancel the configuration on the screen and reset the data on the screen to
the latest value of the switch.
5. Click Refresh to update the screen with the current information.
The following table describes Stack Port Configuration fields.
Field
Unit ID
Port
Running Stack Mode
Link Status
Link Speed (Gbps)
Transmit Data Rate (Mbps)
Transmit Error Rate
Total Transmit Errors
Data Rate (Mbps)
Receive Error Rate
Total Receive Errors
Description
Displays the unit.
Displays the stackable interfaces on the given unit.
Displays the run-time mode of the stackable interface.
Displays the link status (UP/DOWN) of the port.
Displays the maximum speed of the stacking port.
Displays the approximate transmit rate on the stacking port.
Displays the number of errors in transmit packets per second.
Displays the total number of errors in transmit packets since boot. The
counter may wrap.
Displays the approximate receive rate on the stacking port.
Displays the number of errors in receive packets per second.
Displays the total number of errors in receive packets since boot. The
counter may wrap.
67