Service Configuration - NETGEAR GS728TS Admin Manual
Gigabit smart switches
Hide thumbs
Also See for GS728TS:
- Hardware installation manual (42 pages) ,
- Specifications (3 pages) ,
- Installation manual (2 pages)
Table of Contents
Advertisement
GS728TS, GS728TPS, GS752TS, and GS752TPS Gigabit Smart Switches
Service Configuration
Use the Service Configuration page to activate a policy on an interface.
To display the page, click QoS > DiffServ > Advanced > Service Configuration.
To configure DiffServ policy settings on an interface:
1.
To configure DiffServ policy settings for a physical port, click the unit ID of the stack
member with the ports to configure.
2.
To configure DiffServ policy settings for a Link Aggregation Group (LAG), click LAGS.
3.
To configure DiffServ policy settings for both physical ports and LAGs, click ALL.
4.
Select the check box next to the port or LAG to configure. You can select multiple ports and
LAGs to apply the same setting to the selected interfaces. Select the check box in the
heading row to apply the same settings to all interfaces.
5.
To activate a policy for the selected interface(s) select the policy from the Policy In menu,
and then click Apply.
6.
To remove a policy from the selected interface(s) select None from the Policy In menu, and
then click Apply.
7.
Click Cancel to cancel the configuration on the screen and reset the data on the screen to
the latest value of the switch.
195
Advertisement
Table of Contents
