NETGEAR GS728TS Admin Manual page 153

GS728TS, GS728TPS, GS752TS, and GS752TPS Gigabit Smart Switches
To configure the Multicast Router VLAN:
1. Use the Interface menu to select the interface to configure.
2. Enter the VLAN ID in the VLAN ID field for which the Multicast Router Mode is to be
Enabled or Disabled.
3. Use the Multicast Router field to enable or disable Multicast Router on the selected
interface.
4. Click Apply to apply the new settings to the switch. Configuration changes take effect
immediately
5. Click Cancel to cancel the configuration on the screen and reset the data on the screen to
the latest value of the switch.
Querier Configuration
Use this page to enable or disable the MLD Querier Configuration feature, specify the IP
address of the router to perform the querying, and configure the related parameters.
To access this page, click Switching
To configure the Querier settings:
1. From the Querier Admin Mode field, enable or disable the administrative mode for
MLD Snooping Querier.
2. In the Querier Address field, specify the Snooping Querier Address to be used as source
address in periodic MLD queries. This address is used when no address is configured on
the VLAN on which query is being sent. The supported IPv6 formats are x:x:x:x:x:x:x:x and
x::x.
3. In the MLD Version field, the MLD protocol version used in periodic MLD queries is
displayed. The supported MLD Version is 1.
 
Multicast MLD Snooping
153

Querier Configuration.