Lacp Configuration - NETGEAR GS728TS Admin Manual
Gigabit smart switches
Hide thumbs
Also See for GS728TS:
- Hardware installation manual (42 pages) ,
- Specifications (3 pages) ,
- Installation manual (2 pages)
Table of Contents
Advertisement
GS728TS, GS728TPS, GS752TS, and GS752TPS Gigabit Smart Switches
LACP Configuration
To display the LACP Configuration page, click Switching> LAG > Advanced > LACP
Configuration.
To configure LACP:
1.
From the LACP System Priority field, specify the device's link aggregation priority
relative to the devices at the other ends of the links on which link aggregation is
enabled. A higher value indicates a lower priority. You can change the value of the
parameter globally by specifying a priority from 0–65535. The default value is 32768.
2.
Click Refresh to reload the page and display the most current information.
3.
Click Cancel to cancel the configuration on the screen and reset the data on the screen to
the latest value of the switch.
4.
If you make any changes to this page, click Apply to send the updated configuration to the
switch. Configuration changes take effect immediately.
108
Advertisement
Table of Contents
