Arp Create - NETGEAR GS728TS Admin Manual

GS728TS, GS728TPS, GS752TS, and GS752TPS Gigabit Smart Switches
Field
Type
Age
Click Refresh to refresh the page with the most current data from the switch.

ARP Create

Use this page to add a static entry to the ARP table.
To display the page, click Routing
To configure a static ARP entry:
1. In the IP Address field, enter the IP address that you want to add. It must be the IP
address of a device on a subnet attached to one of the switch's existing routing
interfaces.
2. In the MAC Address field, enter the unicast MAC address of the device. The format is six
two-digit hexadecimal numbers separated by colons, for example 00:06:29:32:81:40.
3. Click Add to add an ARP Entry.
4. If you made any changes to existing entries, click Apply to update the settings.
5. To delete an entry, select the box associated with the entry and click Delete.
6. Click Cancel to cancel the configuration on the screen and reset the data on the screen to
the latest value of the switch.
Description
The type of the ARP entry. Possible values are:
• Local. An ARP entry associated with one of the switch's routing
interface's MAC addresses.
• Gateway. A dynamic ARP entry whose IP address is that of a router.
• Static. An ARP entry configured by the user.
• Dynamic. An ARP entry which has been learned by the router.
Age since the entry was last refreshed in the ARP Table. The format is
hh:mm:ss.

ARP, then click the Advanced
173

ARP Create link.