Policy Configuration - NETGEAR GS728TS Admin Manual

GS728TS, GS728TPS, GS752TS, and GS752TPS Gigabit Smart Switches
• Source IP Address. Requires a packet's source port IP address to match the
address listed here. In the IP Address field, enter a valid source IP address in dotted
decimal format.
• Source Prefix/Length. Enter a valid source IPv6 prefix to compare against an IPv6
packet. The prefix is always specified with the prefix length. The prefix can be in the
range of ::0 to FFFF:FFFF:FFFF:FFFF:FFFF:FFFF:FFFF:FFFF. The prefix length
range is 0–128.
• Source L4 Port. Requires a packet's TCP/UDP source port to match the port you
select. Select the desired L4 keyword from the list on which the rule can be based. If
you select Other, the screen refreshes and a Port ID field appears. Enter a
user-defined Port ID by which packets are matched to the rule.
• Destination Prefix/Length. Requires a packet's destination IPv6 prefix and length
matches the address listed here. The prefix can be in the range of ::0 to
FFFF:FFFF:FFFF:FFFF:FFFF:FFFF:FFFF:FFFF. The prefix length range is 0–128.
• Destination L4 Port. Requires a packet's TCP/UDP destination port to match the
port you select. Select the desired L4 keyword from the list on which the rule can be
based. If you select Other, the screen refreshes and a Port ID field appears. Enter a
user-defined Port ID by which packets are matched to the rule.
• Flow Label. This is a 20-bit number that is unique to an IPv6 packet. It is used by end
stations to signify QoS handling in routers. The range is 0 to 1048575.
• IP DSCP. Matches the packet's DSCP to the class criteria's when selected. Select the
DSCP type from the menu or enter a DSCP value to match. If you select Other, enter
a custom value in the DSCP Value field that appears.
3. Click Cancel to cancel the configuration on the screen and reset the data on the screen to
the latest value of the switch.
4. If you change any of the settings on the page, click Apply to send the updated configuration
to the switch. Configuration changes occur immediately.
5. Click Refresh to refresh the page with the most current data from the switch.

Policy Configuration

Use the Policy Configuration page to associate a collection of classes with one or more policy
statements. After creating a Policy, click the policy link to the Policy page.
To display the page, click QoS > DiffServ > Advanced > Policy Configuration.
191