Protocol Based Vlan Group Membership - NETGEAR GS728TS Admin Manual

GS728TS, GS728TPS, GS752TS, and GS752TPS Gigabit Smart Switches
To access the Protocol Based VLAN page, click Switching
Based VLAN Group Configuration.
To configure a Protocol Based VLAN Group:
1. Enter a number used to identify the group created by the user. Group IDs should be
assigned when a group is created by the user. The Group IDs range is 1–128.
2. Assign a name to a new group in the Group Name field. You may enter up to 16 characters.
3. Populate the Protocol(s) field - Protocol-list can be any valid comma(,) separated string with
standard "arp", "ip", "ipx" keywords, hexadecimal, or decimal values in the range of
0x0600(1536) to 0xFFFF(65535).
4. Enter any number in the range of (1 to 4093) VLAN ID field. All the ports in the group will
assign this VLAN ID to untagged packets received for the protocols you included in this
group.
The Ports field displays all the member ports which belong to the group.
5. To add an entry of MAC Address to VLAN mapping, click Add.
6. To remove the Protocol Based VLAN group identified by the value in the Group ID field,
click Delete.
7. Click Cancel to cancel the configuration on the screen and reset the data on the screen to
the latest value of the switch.
If you make any changes to this page, click Apply to send the updated configuration to the switch.
Configuration changes take place immediately.

Protocol Based VLAN Group Membership

To access the MAC Based VLAN page, click Switching
Based VLAN Group Membership. In the following image, the port list has been expanded to
display the available ports on the system.

VLAN
 
VLAN
116
 
Advanced Protocol

Advanced Protocol