Advanced-Lacp Configuration; Advanced-Lacp Port Configuration - NETGEAR GS108T - ProSafe - Gigabit Smart Switch Software Administration Manual

Advanced—LACP Configuration
The LACP Configuration screen lets you set the LACP system priority, which specifies the
device's link aggregation priority relative to the devices at the other ends of the links on which link
aggregation is enabled. To configure LACP:
1. Select Switching > LAG > Advanced > LACP Configuration. A screen similar to the
following displays.
Figure 4-5
The LACP System Setting field is the only configurable field in this screen:
• LACP System Setting. LACP Port priority ranges from 0 to 65536. A higher value
indicates a lower priority. The default value is randomly selected.
2. Click Apply to confirm any settings changes.
Advanced—LACP Port Configuration
The LACP Port Configuration screen, which is also referred to as the LACP Port Priority screen,
lets you set the LACP port priority and time-out value:
1. Select Switching > LAG > Advanced > LACP Port Configuration. A screen similar to the
following displays.
Configuring Switching
GS108T Smart Switch Software Administration Manual
v1.0, December 2007
4-7