When using overlapping multi-part forms, do not use the paper select (change tractors) or tear
backward.
Notes:
1.
Rough multi-part form binding causes paper jams.
multi-part form sheets should be bound together with spot gluing (dotted paste), paper
2. The
stapling (mechanical staking), or tape stitching. Forms joined with spot gluing are
recommended for the best printing quality.
For multi-part forms joined with dotted paste, the form sheets can be joined on either a single
3.
side or both sides. Figure 1-14 shows the recommended paste positions.
pasted areas must be pressed flat. There must be no creases in the paper.
4. The
Paper stapling must be applied from the front, and the paper must be flat. Figure 1-15 shows a
5.
cross section of the stapled area.
6. Paper stapling must be applied for both feeding directions. Figure 1-16 shows a cross section of
the stapled area.
Rev. A
Surface
o
"
0
0
Figure 1-14. Dotted Paste Positions
a: Less than paper thickness
Figure 1-15. Stapled Area 1
Paper feeding direction
Figure 1-16. Stapled Area 2
Product Description
o
0
0
0
1-9