Disassembly and Assembly
5. Remove the 2 CPN (M3 x 8) screws securing the FPC cover to the bottom plate of the printer
mechanism.
6. Remove the 2 FPC printhead cables from the connector junction board on the bottom plate
and remove the
2
the printhead with the PW sensor and the masldess holder.
Ribbon Fee
BOARD
TRACTOR ASSEMBLY
(REAR)
When you install the printhead, perform the platen gap motor value (platen gap) adjustment
described in Section 4.1.7.
3-8
Figure 3-8. Removing the Printhead
Rev. A