Removifig The Pull Tractor Sensor - Epson C117001-N - DFX 5000+ B/W Dot-matrix Printer Service Manual

3.2.7.10 Removing the Pull Tractor Sensor
1. Remove the upper paper guide. (Refer to Section 3.2.7.6)
2. Disconnect the red, 2-pin, pull tractor sensor comector from the connector junction board
assembly.
3. Remove the CPN (SP) (M2 x 14) screw securing the pull tractor sensor (a micro-switch type
sensor) to the left side frame and remove the sensor.
Figure 3-46. Removing the Pull Tractor Sensor
3.2.7.11 Removing the Paper MMth (PW) Sensor
1.
Remove theprinthead. (Refer to S@ion3.2.1)
2. Remove the CPN (SP) (M2 x 6) screw securing the PW sensor to the masldess holder.
Rev. A
Figure 3-47. Removing the PW Sensor
Disassembly and Assambly
SENSOR ASSY.,
PULL TRACTOR
HOLDER
PLATEN
(RIGHT)
Nut
Hexagon