Figure 3-33. Disassembling The Tractor Select Lever - Epson C117001-N - DFX 5000+ B/W Dot-matrix Printer Service Manual

3.2.7.2 Disassembling the Front/Rear Tractor Select Lever Assembly
This describes how to disassemble the front/rear tractor select lever assembly, including
section
how to remove the RF motor and tractor select sensor.
1. Remove the front/rear tractor select lever assembly. (Refer to Section 3.2.7.1)
2.
lever assembly and remove the motor. Discomect the cable from the black comector on the
RF motor.
3. Remove the E ring (#3) securing the front/rear tractor select lever and remove the lever.
Remove the E ring (# 3) securing the tractor select cam and remove the mm.
Remove the CPS (IW2 x 10) screw securing the tractor select sensor and remove the wnsor.
.'\
5. Using wire cutters, cut the wire band securing the RF motor and tractor select sensor cables to
the front/rear tractor select lever assembly.
Attach the fiontlrear tractor select leoer to the tractor sekct cam as shown in Figure 3-34.
Rev. A
CP (PS) (M3 x 6) screws securing the RF motor to the front/rear tractor select
2
" /
- - . - - - - A-, -A-
LEVER LOWER

Figure 3-33. Disassembling the Tractor Select Lever

FRAME
I
3-25