Multi-Part Forms; Figure 1-12. Dotted Paste Positions - Epson DFX-8000 Service Manual

1.2.1.4 Multi-part Forms

Printable area:
Copying paper:
Front tractor
Rear tractor
Weight:
Total number of copies
1
2
3
4
5
6
NOTES: 1. N = 6 (front) or 4 (rear). The total paper thicknessof multi-part forms should be less than
the maximum allowable paper thickness.
2. Carbon-less duplicating paper should be used for copying.
3. The copying paper should be joined using dotted paste (S
staples (Tape-stitching).
Dotted paste is recommended for better printing quality.
4. If the dotted paste is used, the paper can be joined either on
Figure 1-12 shows the specified paste positions.
Same with "Single part form" (See Figure 1-3)
Max. 6 sheets (1 original + 5 copies)
Max. 4 sheets (1 original + 3 copies)
Weight of paper is indicated in [Kg], [lb.], and [g/m2].
Table 1-5. Each Part Weight of a Multi-part Form
Each part weight [Kg]
(except the bottom)
45, 55 or 70
34 or 45
34 or 45
3 4
3 4
3 4

Figure 1-12. Dotted Paste Positions

35 – 48 Kg
11 – 15 lb.
4 1 . 4 – 5 6 . 4 g / m 2
1-9
Bottom sheet weight [Kg]
45, 55 or 70
55 or 70
55 or 70
45, 55 or 70
45, 55 or 70
45, 55 or 70
pot-gluing) or 2 points
a single side or on both
REV.-A
paper
sides.