McDATA 316095-B21 - StorageWorks Edge Switch 2/24 Manual page 285

Sequence
connUnitEventId
Syntax
Access
Status
Description
Sequence
connUnitREventTime
Syntax
Access
Status
added by comparing the last known index value with the current
highest index value. The management application should then
update its copy of the event table. If the read interval is too long, it is
possible that there may be events that may not be contained in the
agent's internal event buffer.
For example, an agent may read events 50-75. At the next read
interval, connUnitEventCurrID is 189. If the management app tries
to read event index 76, and the agent's internal buffer is 100 entries
max, event index 76 will no longer be available.
The index value is an incrementing integer starting from one every
time there is a table reset. On table reset, all contents are emptied and
all indices are set to zero. When an event is added to the table, the
event is assigned the next higher integer value than the last item
entered into the table. If the index value reaches its maximum value,
the next item entered will cause the index value to roll over and start
at one again.
::= { connUnitEventEntry 2 }
INTEGER
read-only
deprecated
The internal event Id. Incremented for each event, ranging between 1
and connUnitMaxEvents. Not used as table index to simplify the
agent implementation. When this reaches the end of the range
specified by connUnitMaxEvents, the Id will roll over to start at one.
This value will be set back to one at reset. The relationship of this
value to the index is that internal event id may represent a smaller
number than a 32 bit integer (e.g. max 100 entries) and would only
have a value range up to connUnitMaxEvents.
::= { connUnitEventEntry 3 }
DisplayString (SIZE (0..15))
read-only
mandatory
FC Management MIB
Event Group
B-37
B