McDATA 316095-B21 - StorageWorks Edge Switch 2/24 Manual page 148

McDATA SNMP Support
2
Product Mapping
fcConnUnitPortStatTable - Port statistics
*fcConnUnitPortStatIndex
Product Mapping
fcConnUnitPortStatCountError
Product Mapping
E/OS SNMP Support Manual
2-126
For F ports, return Fibre Channel Address. For E_Ports, return left
adjusted domainId of the switch.
R
Access
This is the Fibre Channel ID of this port. If the connectivity unit is a
Description
switch, this is expected to be a 24-bit Big Endian value. If this is loop,
then it is the ALPA that is connected. If this is an E_Port, then it will
only contain the domain ID. If not any of those, unknown or cascaded
loop, return all bits set to 1.
There is one and only one statistics table for each individual port. For
all objects in statistics table, if the object is not supported by the conn
unit then the high order bit is set to 1 with all other bits set to zero.
The high order bit is reserved to indicate if the object if supported or
not. All objects start at a value of zero at hardware initialization and
continue incrementing till end of 63 bits and then wrap to zero.
Unsigned32
Type
A port number, starting from 1 to maximum number of ports.
R
Access
A unique value among all entries in this table, between 0 and
Description
fcConnUnitNumPort[fcConnUnitPortUnitId].
Counter64
Type
This MIB object counts:
address ID errors,
CRC errors, delimiter errors,
frames too short,
invalid transmission words,
link failures,
primitive sequence errors,
signal losses,