4227-300
Carrier plate removal
1. Remove the top cover. See
2. Remove the print unit.
3. Remove the carrier.
4. Remove the lower pinch roller.
5. Remove the carrier motor.
6. Remove the Auto Gap motor and its bracket.
7. Remove the carrier motor bracket.
8. Remove the right side frame.
9. Remove the two screws holding the carrier plate to the left side
frame, and then remove the carrier plate.
Label jam removal
When a pressure-sensitive label separates from its protective
backing and jams and sticks to the paper separator below the carrier
plate, use the following procedure to remove the label.
1. Remove the top cover. See
4-38.
2. Remove the tractor assembly.
3. Remove the print unit. See
4. Remove the paper separator. See
on page
5. Carefully remove the label from the paper separator. If the label
is jammed below the carrier plate or on the lower portion of the
paper guide/platen assembly, carefully remove the label without
scratching either surface.
4-16
Service Manual
4-27.
"Top cover removal" on page
"Upper feed roller removal" on page
"Print unit removal" on page
"Paper separator removal"
4-5.
4-29.