4227-300
Ribbon drive motor assembly removal
1. Remove the top cover. See
2. Remove the sub logic board.
3. Remove the ribbon drive post cover and the ribbon drive post
(1).
4. Remove the Auto Gap sensor (2) from the motor bracket.
5. Disconnect ribbon motor connector CN19 from the main logic
board.
6. Remove the carrier motor bearing retainer and bearing (3) from
the ribbon motor bracket.
7. Remove the three screws (4) holding the ribbon drive motor
bracket, and then remove the ribbon drive motor assembly.
4-34
Service Manual
"Top cover removal" on page
4-5.