Installing The Cd/Dvd Drive; Completing The Installation - IBM x3655 - System - 7985 User Manual

1. Read the safety information that begins on page v and "Installation guidelines"
2. Turn off the server and peripheral devices, and disconnect the power cords and
3. Place your thumbs on the metal tabs of the fan-bracket-assembly levers and
4. Grasp the levers and lift the fan-bracket assembly out of the server.

Installing the CD/DVD drive

To install a CD/DVD drive, complete the following steps:
1. Read the safety information that begins on page v and "Installation guidelines"
2. Make sure that the server and peripheral devices are turned off, and that the
3. Follow the instructions that come with the drive to set any jumpers or switches.
4. Attach the drive retention clip to the side of the drive.
5. Slide the drive into the CD/DVD drive bay until the drive clicks into place.
If you have other devices to install or remove, do so now. Otherwise, go to

"Completing the installation."

Completing the installation
To complete the installation, complete the following steps:
1. If you removed any air baffles, replace the air baffles (see "Installing the air
2. If you removed the riser-card assembly, replace the riser-card assembly (see
3. If you removed the server cover, replace the server cover (see "Installing the
4. Install the server in a rack. See the Rack Installation Instructions that come with
on page 23.
all external cables. Slide the server out of the rack and remove the cover (see
"Removing the cover" on page 26).
pinch the tab and blue release latch together; then, raise the levers, raising the
fan-bracket assembly.
on page 23.
power cords and all external cables are disconnected. Remove the server from
the rack and remove the cover (see "Removing the cover" on page 26).
Drive retention clip
Alignment pins
baffle" on page 30).
"Installing the riser-card assembly" on page 28).
cover" on page 62).
the server for complete rack installation and removal instructions.
Chapter 2. Installing optional devices
61