Using The Serverguide Setup And Installation Cd - IBM x3655 - System - 7985 User Manual

While the server is turned off, move the jumper on J37 from pins 1 and 2 to pins 2
and 3. You can then start the Configuration/Setup Utility program and reset the
power-on password. After you reset the password, turn off the server again and
move the jumper back to pins 1 and 2.
The power-on password override switch does not affect the administrator password.
Administrator password
If an administrator password is set, you must type the administrator password for
access to the full Configuration/Setup Utility menu. You can use any combination of
up to seven characters (A–Z, a–z, and 0–9) for the password. The Administrator
Password choices on the Configuration/Setup Utility menu only if an optional IBM
Remote Supervisor Adapter II SlimLine is installed.
Attention:
to change, override, or remove it. You must replace the system board.

Using the ServerGuide Setup and Installation CD

The ServerGuide Setup and Installation CD contains a setup and installation
program that is designed for your server. The ServerGuide program detects the
server model and hardware devices that are installed and uses that information
during setup to configure the hardware. The ServerGuide program simplifies
operating-system installations by providing updated device drivers and, in some
cases, installing them automatically.
BIOS recovery (J35)
Power-on password
override (J37)
If you set an administrator password and then forget it, there is no way
Wake-on-LAN
(J33)
Chapter 3. Configuring the server
71