Installing The Cover; Connecting The Cables - IBM x3655 - System - 7985 User Manual

5. To attach peripheral devices and connect the power cords, see "Connecting the

Installing the cover

To install the cover, complete the following steps:
1. Place the cover-release latch in the open (up) position.
2. Insert the bottom tabs of the top cover into the matching slots in the server
3. Press down on the cover-release latch to lock the cover in place.
4. Slide the server into the rack.

Connecting the cables

The following illustrations show the locations of the input and output connectors on
the front and rear of the server.
62
System x3655 Type 7985: User's Guide
Attention:
v Install the server only in a rack cabinet with perforated doors.
v Do not leave open spaces above or below an installed server in the rack
cabinet. To help prevent damage to server components, always install a blank
filler panel to cover the open space and to help ensure proper air circulation.
See the documentation that comes with the rack cabinet for more information.
v Install the server in a rack that meets the following requirements:
– Minimum depth of 70 mm (2.8 in.) between the front mounting flange and
the inside of the front door
– Minimum depth of 157 mm (6.2 in.) between the rear mounting flange and
the inside of the rear door
– Minimum depth of 718 mm (28.3 in.) and maximum depth of 762 mm
(30.0 in.) between the front and rear mounting flanges
cables."
Cover-release
latch
chassis.