10. Install the air baffle (see "Installing the air baffle" on page 30); then, route the
Important: Make sure the SAS cable doesn't interfere with an adapter installed in
the riser-card assembly.
If you have other devices to install or remove, do so now. Otherwise go to
"Completing the installation" on page 61.
Installing the Remote Supervisor Adapter II SlimLine
An optional Remote Supervisor Adapter II SlimLine can be installed only in a
dedicated connector on the riser card. After the Remote Supervisor Adapter II
SlimLine is installed, the systems-management Ethernet port on the rear of the
server is active.
Note: Earlier versions of the Remote Supervisor Adapter II SlimLine might not work
in this server. See http://www.ibm.com./servers/eservers/serverproven/compat/us/
for information about the supported Remote Supervisor Adapter II SlimLine.
cable through the slot in the side of the air baffle.
SAS cable
External SAS
connector
Chapter 2. Installing optional devices
35