Passwords - IBM x3655 - System - 7985 User Manual

v Event/Error Logs
v Save Settings
v Restore Settings
v Load Default Settings
v Load Default Settings
v Exit Setup

Passwords

From the System Security choice, you can set, change, and delete a power-on
password and an administrator password. The System Security choice is on the
full Configuration/Setup menu only.
If you set only a power-on password, you must type the power-on password to
complete the system startup; you have access to the full Configuration/Setup Utility
menu.
An administrator password is intended to be used by a system administrator; it
limits access to the full Configuration/Setup Utility menu. If you set only an
administrator password, you do not have to type a password to complete the
system startup, but you must type the administrator password to access the
Configuration/Setup Utility menu.
This choice is on the Configuration/Setup Utility menu only if a Remote
Supervisor Adapter II SlimLine is installed.
Select this choice to view and clear the POST error log and the system
event/error log.
– Post Error Log
Select this choice to view the three most recent error codes and messages
that were generated during POST. Select Clear POST Error Log to clear the
POST error log.
– System Event/Error Log
Note: This choice is on the Configuration/Setup Utility menu only if a Remote
Supervisor Adapter II SlimLine is installed.
Select this choice to view the error messages in the system event/error log.
You can use the arrow keys to move between pages in the error log. Select
Clear System Event/Error Log to clear the system event/error log.
The system event/error log contains all event and error messages that have
been generated during POST by the systems-management interface handler
and the service processor.
Select this choice to save the changes that you have made in the settings.
Select this choice to cancel the changes that you have made in the settings and
restore the previous settings.
Select this choice to cancel the changes that you have made in the settings and
restore the previous settings.
Select this choice to cancel the changes you have made in the settings and
restore the factory settings.
Select this choice to exit from the Configuration/Setup Utility program. If you have
not saved the changes that you have made in the settings, you are asked
whether you want to save the changes or exit without saving them.
Chapter 3. Configuring the server
69