Installing the riser-card assembly
To install the riser-card assembly, complete the following steps:
1. Read the safety information that begins on page v and "Installation guidelines"
2. Make sure that the server and all peripheral devices are turned off, and that the
3. Reinstall any adapters and reconnect any cables you might have removed in
4. Carefully align the riser-card assembly with the release tab posts, the guides on
If you have other devices to install, do so now. Otherwise, go to "Completing the
installation" on page 61.
28
System x3655 Type 7985: User's Guide
Access holes
on page 23.
power cords and all external cables are disconnected (see "Turning off the
server" on page 13); then, remove the cover (see "Removing the cover" on
page 26).
other procedures.
the rear of the server, and the riser-card connector on the system board; then,
press down on the assembly. Make sure that the riser-card assembly is fully
seated in the riser-card connector on the system board.
Release tabs