Table of Contents
Advertisement
Cover pins
Figure 25. Closing the blade server cover
Complete the following steps to close the blade server cover:
1. Read the safety information beginning on page vii and "Installation guidelines"
2. If you removed the front bezel assembly, replace it now. See "Installing the front
3. Lower the cover so that the slots at the rear slide down onto the pins at the rear
4. Pivot the cover to the closed position as shown in Figure 25 until it clicks into
Input/output connectors and devices
The BladeCenter unit contains the input/output connectors that are available to the
blade server. See the documentation that comes with the BladeCenter unit for
information about the input/output connectors.
Cover release
on page 29.
bezel assembly" on page 51 for instructions.
of the blade server, as shown in Figure 25. Before closing the cover, make sure
that all components are installed and seated correctly and that you have not left
loose tools or parts inside the blade server.
place.
Cover release
Chapter 4. Installing and removing replaceable units
53
Advertisement
Table of Contents
Troubleshooting
