Using The Miscellaneous Parts Kit - IBM QS22 - BladeCenter - 0793 Service Manual

6. Carefully unscrew the retention clip and remove.
7. Position the replacement retention clip over the hole and screw into position,
8. If applicable, replace the modular flash drive.
9. Replace the cover and insert the blade server into the BladeCenter unit.

Using the miscellaneous parts kit

The miscellaneous parts kit contains replacement parts and screws to be used if
the original item is damaged. It contains the following items:
Retention clip screws
taking care not to over-tighten as this might damage the system board.
Kit, Miscellaneous Parts
Alignment socket
Cover for blade server expansion connector
Pivot point blocks for expansion card support
Ball stud for expansion card support
Tray, expansion card support end bracket
Alignment pin
Screw, Plastite 4-20x6.35
Screw, 3.5 x 6 Pan Head, Philips, Planar
QS22 Planar Light box
Impedance Air Baffle top, foam
Impedance Air Baffle DIMM Sides
Impedance Air Baffle DIMM Sides
Impedance Air Baffle VRD heat sink, foam
Impedance Air Baffle VRD heat sink, foam
Ball stud screws
Chapter 4. Installing and removing replaceable units
Quantity Part No
4 26K6003
4 28R3024
4 31R2232
4 31R2233
2 31R2248
2 39M6518
8 39R9558
6 26K5962
2 43W9782
2 43W9966
2 43W9958
2 43W9959
2 43W9967
2 43W9969
49