Table of Contents
Advertisement
If you have changed the configuration of the blade server or if this is a different
blade server than the one you removed, you must configure the blade server. You
might also have to install the blade server operating system.
See the "Installing the operating system" in the online information or the
Installation and User's Guide PDF for detailed information about these tasks.
See Chapter 5, "Installing the operating system," on page 55.
Input/output connectors and devices
The input/output connectors that are available to the blade server are supplied by
the BladeCenter unit.
See the documentation that comes with the BladeCenter unit for information about
the input/output connectors.
The blade server has a media-tray select button on the control panel. See "Blade
server control panel buttons and LEDs" on page 13 for information about this
button and its function.
The Ethernet controllers on the blade server communicate with the network
through the Ethernet-compatible I/O modules on the BladeCenter unit. Network
signals to and from the blade server or any expansion cards are automatically
routed to a same-network-interface I/O module through circuitry in the
BladeCenter unit.
46
JS23/JS43 Type 7778: Installation and User's Guide
Advertisement
Table of Contents
