IBM QS22 - BladeCenter - 0793 Service Manual page 100

Table 12. DIMM boot errors (continued)
Code Message
E1200 Error during memtest.
This message appears with one of
the following informational
messages:
Detected MIC SRAM parity error.
Detected MIC Data write error.
Detected single-bit ECC error
(recoverable) on DIMM x or DIMM
y.
Detected multi-bit ECC
uncorrectable error on DIMM x or
DIMM y.
Stuck data bit on DIMM x.
Stuck address bit on DIMM x.
E1300 No memory available at address
zero. Aborting system boot.
82
BladeCenter QS22 Type 0793: Problem Determination and Service Guide
Description
Memory test failed
MIC SRAM parity failed during
memtest.
MIC detected a parity error in an
internal buffer.
MIC DERR during memtest
MIC received a DERR condition
from another on chip unit upon a
write request from that unit.
A correctable error occurred
during memtest.
An uncorrectable error occurred
during memtest
Stuck data bit during memtest.
One or more data lanes failed in
the stuck bit test.
Stuck address bit during memtest.
One or more address lanes failed
in the stuck bit test.
No memory is assigned to
address 0. Due to error E1100 all
memory attached to CPU with
address zero must be disabled.
Action
Replace the DIMM where the
error occurred with a supported
DIMM.
See Chapter 3, "Parts listing," on
page 27* for details of supported
DIMMs.
Replace the DIMM where the
error occurred with a supported
DIMM.
See Chapter 3, "Parts listing," on
page 27 for details of supported
DIMMs.
Replace the DIMM where the
error occurred with a supported
DIMM.
See Chapter 3, "Parts listing," on
page 27 for details of supported
DIMMs.
Replace the DIMM where the
error occurred with a supported
DIMM.
See Chapter 3, "Parts listing," on
page 27 for details of supported
DIMMs.
Replace the DIMM where the
error occurred with a supported
DIMM.
See Chapter 3, "Parts listing," on
page 27 for details of supported
DIMMs.