Viewing Mesh Statistics For A Mesh Access Point - Cisco Mesh Access Points Deployment Manual

Viewing Mesh Statistics for a Mesh Access Point

Column
POE Status
Primary Controller
Radio MAC
Reg. Domain Supported
Serial Number
Slot
Tx Power Control
Tx Power Level
Up Time
WLAN Override Names
WLAN Override
Viewing Mesh Statistics for a Mesh Access Point
Mesh Statistics are reported when a child mesh access point authenticates or associates with a parent mesh
access point.
Security entries are removed and no longer displayed when the child mesh access point disassociates from
the controller.
Cisco Mesh Access Points, Design and Deployment Guide, Release 7.3
242
Managing Mesh Access Points with Cisco Prime Infrastructure
Options
Indicates the Power-over-Ethernet status of the access point. The possible
values are as follows:
• Low—The access point draws low power from the Ethernet.
• Lower than 15.4 volts—The access point draws lower than ?15.4
V from the Ethernet.
• Lower than 16.8 volts—The access point draws lower than ?16.8
V from the Ethernet.
• Normal—The power is high enough for the operation of the access
point.
• Not Applicable—The power source is not from the Ethernet.
Indicates the name of the primary controller for this access point.
Indicates the radio's MAC address.
Indicates whether or not the regulatory domain is supported.
Indicates the access point's serial number.
Indicates the slot number.
Indicates whether the transmission power control is automatic or custom.
Indicates the transmission power level.
Indicates how long the access point has been up in days, hours, minutes,
and seconds.
Indicates the WLAN override profile names.
Indicates whether WLAN Override is enabled or disabled. Each access
point is limited to 16 WLAN profiles. Each access point broadcasts all
WLAN profiles unless the WLAN override feature is enabled. The
WLAN override feature allows you to disable any of the 16 WLAN
profiles per access point.
OL-27593-01