Troubleshooting; Installation And Connections - Cisco Mesh Access Points Deployment Manual

Troubleshooting

This chapter describes troubleshooting information and contains the following section:
•

Installation and Connections

Step 1 Connect the mesh access point that you want to be the RAP to the controller.
Step 2 Deploy the radios (MAP) at the desired locations.
Step 3
On the controller CLI, enter the show mesh ap summary command to see all MAPs and RAPs on the controller.
Figure 83: Show Mesh AP Summary Page
OL-27593-01
Installation and Connections, page 207
C H A P T E R
Cisco Mesh Access Points, Design and Deployment Guide, Release 7.3
7
207