Adding Mac Addresses Of Mesh Access Points To Mac Filter; (Gui) - Cisco Mesh Access Points Deployment Manual

Connecting the Cisco 1500 Series Mesh Access Points to the Network

Adding MAC Addresses of Mesh Access Points to MAC Filter

You must enter the MAC address for all mesh access points that you want to use in the mesh network into
the appropriate controller. A controller only responds to discovery requests from outdoor radios that appear
in its authorization list. MAC filtering is enabled by default on the controller, so only the MAC addresses
need to be configured. If the access point has an SSC and has been added to the AP Authorization List, then
the MAC address of the AP does not need to be added to the MAC Filtering List.
You can add the mesh access point using either the GUI or the CLI.
You can also download the list of mesh access point MAC addresses and push them to the controller using
Note
Cisco Prime Infrastructure.
Adding the MAC Address of the Mesh Access Point to the Controller Filter List (GUI)
To add a MAC filter entry for the mesh access point on the controller using the controller GUI, follow these
steps:
Step 1 Choose Security > AAA > MAC Filtering. The MAC Filtering page appears.
Figure 44: MAC Filtering Page
Step 2 Click New. The MAC Filters > New page appears.
Step 3
Enter the MAC address of the mesh access point.
OL-27593-01
Adding MAC Addresses of Mesh Access Points to MAC Filter
Cisco Mesh Access Points, Design and Deployment Guide, Release 7.3
101