Mesh Access Point Cli Commands - Cisco Mesh Access Points Deployment Manual

Mesh Access Point CLI Commands

The question mark (?) and the exclamation point (!) should not be used in the send cmodem command.
Caution
These characters have immediate interpreted use in the Cisco IOS CLI. Therefore, they cannot be sent to
the modem.
Mesh Access Point CLI Commands
You can enter these commands directly on the mesh access point using the AP console port or you can use
the remote debug feature from the controller:
Cisco Mesh Access Points, Design and Deployment Guide, Release 7.3
212
Troubleshooting
OL-27593-01