Viewing General Mesh Network Details - Cisco Mesh Access Points Deployment Manual

Cisco mesh access points, design and deployment guide, release 7.3
Table of Contents

Advertisement

Viewing General Mesh Network Details

Viewing General Mesh Network Details
To view general mesh network details, enter these commands:
• show mesh env {summary | AP_name}—Shows the temperature, heater status, and Ethernet status for
• show mesh ap summary—Revised to show the CERT MAC field that shows a MAC address within
Cisco Mesh Access Points, Design and Deployment Guide, Release 7.3
194
either all access points (summary) or a specific access point (AP_name). The access point name, role
(RootAP or MeshAP), and model are also shown.
◦ The temperature is shown in both Fahrenheit and Celsius.
◦ The heater status is ON or OFF.
◦ The Ethernet status is UP or DOWN.
The battery status appears as N/A (not applicable) in the show mesh env AP_name
Note
status display because it is not provided for access points.
(Cisco Controller) >
AP Name
------------------
SB_RAP1
SB_MAP1
SB_MAP2
SB_MAP3
(Cisco Controller >
AP Name.......................................... SB_RAP1
AP Model......................................... AIR-LAP1522AG-A-K9
AP Role.......................................... RootAP
Temperature...................................... 39 C, 102 F
Heater........................................... OFF
Backhaul......................................... GigabitEthernet0
GigabitEthernet0 Status.......................... UP
Duplex....................................... FULL
Speed........................................ 100
Rx Unicast Packets........................... 988175
Rx Non-Unicast Packets....................... 8563
Tx Unicast Packets........................... 106420
Tx Non-Unicast Packets....................... 17122
GigabitEthernet1 Status.......................... DOWN
POE Out........................................ OFF
Battery.......................................... N/A
an AP certificate that can be used to assign a username for external authentication.
show mesh ap summary
(Cisco Controller) >
AP Name AP Model
------- ---------------
R1
LAP1520
R2
LAP1520
H2
AIR-LAP1522AG-A-K9 00:1a:a2:ff:f9:00
Number of Mesh APs............................... 3
Number of RAP................................... 2
Number of MAP................................... 1
show mesh env summary
Temperature(C/F)
Heater
----------------
------
39/102
OFF
37/98
OFF
42/107
OFF
36/96
OFF
show mesh env SB_RAP1
BVI MAC
CERT MAC
-----------------
---------------- ---- -----------------
00:0b:85:63:8a:10
00:0b:85:63:8a:10 0
00:0b:85:7b:c1:e0
00:0b:85:7b:c1:e0 1
00:1b:d4:a6:f4:60 1
Checking the Health of the Network
Ethernet
Battery
--------
-------
UpDnNANA
N/A
DnDnNANA
N/A
DnDnNANA
N/A
DnDnNANA
N/A
Hop Bridge Group Name
y1
y1
OL-27593-01

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents