Workgroup Bridge Output - Cisco Mesh Access Points Deployment Manual

Cisco mesh access points, design and deployment guide, release 7.3
Table of Contents

Advertisement

Managing Mesh Access Points with Cisco Prime Infrastructure
ap(config)#
ap(config-subif)#
ap(config-subif)#
ap(config-subif)#
ap(config)#
ap(config-subif)#
ap(config-subif)#
ap(config-subif)#
ap(config)#
ap(config-subif)#
ap(config-subif)#
ap(config-subif)#
ap(config)#
ap(config-subif)#
ap(config-subif)#
ap(config-subif)#
ap(config)#
ap(config-ssid)#
ap(config-ssid)#
ap(config-ssid)#
ap(config-ssid)#
ap(config)#
ap(config-if)#
ap(config-if)#
ap(config-if)#
ap(config)#
ap(config)#
The bridge irb command is used to enable integrated routing and bridging, which the Auto AP code has
retained from other higher end platforms.
You have to create dynamic interfaces 184 and 185 on the WLC for the above configuration to work. The
WGB updates the WLC about the wired-client VLAN information in the IAPP association message. The
WLC treats the WGB client as a VLAN-client and forwards the packet in the right VLAN interface based on
the source MAC address. In the upstream direction, the WGB removes the 802.1Q header from the packet
and sends it to the WLC. In the downstream direction, the WLC sends the packet to the WGB without the
802.1Q tag and the WGB adds the 802.1Q header based on the destination MAC address, while forwarding
the packet to the switch that connects the wired client.

Workgroup Bridge Output

Enter the following command:
sh bridge
WGB#
Total of 300 station blocks, 292 free
Codes: P - permanent, S - self
OL-27593-01
int FastEthernet0.184
encapsulation dot1q 184 native
bridge-group 1
exit
int FastEthernet0.185
encapsulation dot1q 185
bridge-group 185
exit
int Dot11Radio 1.185
encapsulation dot1q 185
bridge-group 185
exit
int Dot11Radio 1.184
encapsulation dot1q 184 native
bridge-group 1
exit
dot11 ssid auto-wgb
authentication open
infrastructure-ssid
VLAN 184
exit
int Dot11Radio 1
station-role workgroup-bridge
ssid auto-wgb
exit
bridge irb
hostname WGB
Cisco Mesh Access Points, Design and Deployment Guide, Release 7.3
Multiple VLAN and QoS Support for WGB Wired Clients
253

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents