Link Test Result - Cisco Mesh Access Points Deployment Manual

Workgroup Bridge Interoperability with Mesh Infrastructure

Link Test Result

Figure 74: Link Test Results
A link test can also be run from the controller CLI using the following command:
(Cisco Controller) >
Link tests from the controller are only limited to the WGB, and they cannot be run beyond the WGB from
the controller to a wired or wireless client connected to the WGB. You can run link tests for the wireless client
connected to the WGB from the WGB itself using the following command:
dot11 dot11Radio 0 linktest target client-mac-address
ap#
Start linktest to 0040.96b8.d462, 100 512 byte packets
ap#
POOR (4% lost)
Sent: 100
Lost to Tgt: 4
Lost to Src: 4
Rates (Src/Tgt)
Linktest Done in 24.464 msec
Cisco Mesh Access Points, Design and Deployment Guide, Release 7.3
166
Connecting the Cisco 1500 Series Mesh Access Points to the Network
linktest client mac-address
Time (msec) Strength (dBm)
In
Avg. 22 -37
Max. 112 -34
Min. 0 -40
24Mb 0/5 36Mb 25/0 48Mb 73/0
SNR Quality
Out In Out
-83 48 3
-78 61 10
-87 15 3
54Mb 2/91
Retries
In Out
Tot. 34 35
Max. 10 5
OL-27593-01