External Remote Control; Remote Operation Of External Devices - Panasonic AJHPM110E - MEMORY CARD PORTABLE RECORDER/PLAYER Operating Instructions Manual

Remote operation of external devices

Use the RS-422A or IEEE1394 interface to send commands to
an external device to control it.
The following functions permit remote control.
• PLAY, STOP, STILL, FF, REW, SHTL, JOG
• Counter and status LED indication
Setup Procedure
1
Perform either of the following steps when the
THUMBNAIL and PLAY LIST buttons are off.
• In the RS-422 interface, press the EVENT button.
• In the IEEE1394 interface, hold down the SHIFT button
and press the EVENT button.
1
• This allows the unit to perform remote control of external
devices.
◆ NOTE:
• Select 59.94, 50, 23.98, 24, 29.97 or 25 in setup menu No. 25
SYSTEM FREQ when using RS-422A.
• Select 59.94 or 50 in setup menu No. 25 SYSTEM FREQ when using
IEEE1394.
*1
• In AVC-Intra50 and AVC-Intra100
output are not available.
• Complete any settings required for controlling a remotely connected
device before pressing the EVENT button.
*1 Available when the optional AVC-Intra Codec board AJ-YBX200G
is installed

External Remote Control

*1
formats, IEEE1394 input and
Using USB Connectors and SD/SDHC Memory Cards: External Remote Control
Indications during control of external
devices
In external control mode, the EVENT lamp goes on and the
unit provides the following indications.
• The LED goes on to indicate external device status.
• Indicates the external device counter
• The unit is forcibly set to EE to enable reception of audio
and video from the external device
• Counter, status and P mark indications for the external
device are superimposed on the screen.
◆ NOTE:
When 1394 input is selected and the unit is in STILL mode, it goes into
EE mode after engaging STOP mode.
Remote operation procedure
The control buttons listed below enable remote control of an
external device.
STOP Sends the STOP command.
PLAY Sends the PLAY command.
STILL Sends the STILL +0.0 command
REW Sends the REW command.
FF Sends the FF command.
Dial Sends the SHTL or JOG command.
*1
COUNTER Sends the switch COUNTER command
(CTL/TC only).
*1
RESET Sends the 0 reset command in CTL mode.
*1 Available only when using RS-422A
113