Table of Contents
Advertisement
Changing Thumbnail Display
The thumbnail screen can be customized to suit operating
conditions and improve efficiency.
Switching the Type of Information That is
Displayed
1
4
3
2
1
Open the thumbnail screen.
2
Press the MENU button.
3
Use the cursor buttons to select the clip type that
should appear under [THUMBNAIL].
ALL CLIP:
Show all clips
SAME FORMAT
Show clips in the same format as
CLIPS:
the system
◆ NOTE:
• When 23.98, 24, 29.97, 59-23, 60-24,
25 or 60-25 is selected in setup
menu No. 25 SYSTEM FREQ, only
clips in a format that can be
recorded appear.
SELECTED
Show clips selected using the SET
CLIPS:
button
MARKED CLIPS: Show clips to which shot marks
have been attached
TEXT MEMO
Show clips that contain text memo
CLIPS:
data
◆ NOTE:
In the following instances, the
thumbnail in the row below at the text
memo location may be grayed out
when a text memo clip appears.
• An AVC-Intra clip when an optional
AVC-Intra codec board has not been
installed.
• An AVC-Intra clip with a different
SYSTEM FREQ. setting
SLOT CLIPS:
Show clips on P2 card in slot No. n
4
Press the SET button.
◆ NOTE:
(These operations can also be performed using buttons.)
• Press SHIFT + IN and the indication changes in the following
order each time these buttons are pressed: SELECTED ➝ SLOT
1 ➝ SLOT 2 ... SLOT 6 ➝ SELECTED. (Only slots with cards will
appear.)
• Press SHIFT + OUT to switch to ALL CLIP.
Clip Management: Thumbnail and Clip Management
45
Advertisement
Table of Contents
